Part number top oil pressure switch y61
 

Hi guys, anybody know what the part number is for the oil pressure switch near the manifold for a y61 3.0d 2004? Thanks Geoff

Presume this would be common across any of the ZD30's, so one of the 3litre Terrano boys may be able to help you out :thumbs

i put new one in my 3l but cant remember/find the reciept.dont forget there are 2 oil switches on 3l low/high i do remember the high has a yellow band on it though.drivers side.

Hi Geoff
How do you know that pressure switch needs replacing.?
Davey

That's the one I need too, I know this as I've already replaced the other one and still got the fault

Sent from my SM-A520F using Tapatalk

You may need to buy the update kit, not just the switch if you have the fault.

Kind regards

Russell.

Most of the time the switch on the bottom is the one that needs replacing.
On my truck both are changed, but in the end there was a problem with the wiring.

oil light stays on,then you put new pressue switch in next to oil filter,cheap,but light stays on,so you have to change switch,dearer, on off side.the mod is just a fitting about 1.5" long that fits between block and switch.

I got fed up of the oil light sensor going on the fitz so I just fitted an oil pressure gauge and earthed the light.

The mod just makes it less likely to break but doesn't fix it for good.

Found it but not sure which is whichhttps://uploads.tapatalk-cdn.com/201...1becc22b60.jpg

Sent from my Pixel 3a using Tapatalk