:::.Nissan 4x4 Owners Club.:::

:::.Nissan 4x4 Owners Club.::: (http://www.nissan4x4ownersclub.com/forum/index.php)
-   I'm new here, please be gentle (http://www.nissan4x4ownersclub.com/forum/forumdisplay.php?f=39)
-   -   key fob (http://www.nissan4x4ownersclub.com/forum/showthread.php?t=30414)

billybuilder 11-02-2020 20:48

key fob
 
AGGGGH can't get the key fob reprogramme sequence to work following change of battery on my 2002 X Trail.

Locks manually and obviously starts but have put the key in and out of the ignition 6+ times over and over again and can't get the lights to flash . Only had it a few weeks and it is driving me mad ......everything else is fine ....love it .

Can any of the experienced x trailers help ??

solarman216 12-02-2020 00:53

Is the Xtrail different programming sequence to a T2 then? key in and out sounds wrong to me, Rick

billybuilder 12-02-2020 09:04

Thanks Rick I am relying on the workshop manual that I downloaded. Is there another option ?

Les

macabethiel 12-02-2020 10:47

Change of Battery
 
Quote:

Originally Posted by billybuilder (Post 367162)
AGGGGH can't get the key fob reprogramme sequence to work following change of battery on my 2002 X Trail.

Locks manually and obviously starts but have put the key in and out of the ignition 6+ times over and over again and can't get the lights to flash . Only had it a few weeks and it is driving me mad ......everything else is fine ....love it .

Can any of the experienced x trailers help ??

Daft question but did the unit work fine until you changed the battery or did you replace the battery as the remote was not working so you thought it was a flat battery ?

If its the former then you would not normally need to re-teach the fob just because you changed the battery. On some vehicles if a key such as a spare is not used for a long period and the battery is flat then a re-teach might be required.

If its the latter might be worth getting the key fob repaired.

billybuilder 12-02-2020 11:05

It was working when I bought it but the failed once or twice and I thought it was because the rubber/buttons and or battery were worn so I sent it to a highly recommended guy on eBay for a refurb. Now I can't seem to reprogram it. Since original post I seem to be able to get the car in reprogram mode but can go no further !!What fun

solarman216 11-03-2020 23:00

On a Terrano it is turn on and off 6 times within 10 seconds and leave it off, the lights should flash twice to confirm programming mode, then hold unlock button and press lock button 3 times, lights should flash to say accepted, if OK turn ign on and lights should flash again to complete, I only remembered that as tried it on the Mrs motor the other day but fob clearly not working so will source another, Rick

jims-terrano 12-03-2020 07:48

I’ve had similar problems in the past. I was lucky enough to have two sets of terrano keys so borrowed a know working which programmed fine. I suspect it might be one of your keys is faulty.

billybuilder 12-03-2020 18:44

Thanks for your time and advice guys.

Les


All times are GMT +1. The time now is 12:56.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.