Wanted: Starter motor bolt!
 

As header, the replacement bolt has come out and obviously need a new one. New one required.

Just the one Simon?:nenau

Just the one! :)

Will look in workshop tomorrow, Zac did you tighten it up nice and tight, if so then could be the thread in the bell housing is getting slack, Rick

That was as tight as you like!!!!! I suspect the threads are no good :O

Cheers Rick. And I'm not in the mood for goosed threads in bellhousings today...
I could be in the market for a Bosch fuel pump too.:(

What is the mater with your pump? Rick

Suspected leak. I need to give it a bit of a clean and good look, but it'd be nice to know if one's available.

I've used mine

Got a couple of bolts, PM me your addy and I will send them off, Rick

Received and installed, thanks Rick. :thumbs
What a pig of a job, Now that I've worked a way of supporting the starter motor (wood wedged underneath at the front), locating and cartching the thread becomes a lot easier. We're up and running again.
Obviously I'll keep an eye on it, it is a tight as I could get with a spanner.

:clap

Awkward job innit mate

I deffo spannered those in hard!!!!!!

I reckon you've got thread wear so keep an eye on it mate