Quote:
Originally Posted by george
Always someone negative... Rick has been sent the email
1k pot across pins 2 and 3 on the fuel pump loom, works for Bosch or zexel
Dyno proven 30bhp and 100nm gains
|
Sorry George, can I just ask a few questions please?
How do you set the pot up for best performance? Is it trial and error, or is there a procedure?
Is it worth mounting the pot on the Dash, so you can wind it up or down, as and when needed, or is it best in a box under the bonnet, so once setup you just leave it alone?
You say across pin 2 and 3, is this connector down on the fuel pump, or one of the ones up on the top of the engine?
Thanks.