Quote:
Originally Posted by zippy656
Ok so...
Alko make a removeable handle about £50 ��
But!!!!
Remover spare wheel.
Remover bracket ��
.
.
.
.
.
.
.
Now the clever bit rorate bracket 180 deg. And refit. Wheel should be 2" higher.
Also make sure you got the long neck tow ball
|
But there is still a need for the handle to travel upwards, so no gain really.
My bracket does not raise the spare wheel by any significant amount when rotated so that was out. However drilling 4 new holes 20mm lower & 35mm to right has made a very noticeable difference. Enough not to need further mods. Only downside is that, if approached at an angle from the nearside, hitching-up is more difficult. However other angles are much easier.