Quote:
Originally Posted by Lazy-Ferret
Did you ever fit this in the end Zac?
I got one for Suz's car, but where ever I position the rear clamp, it bangs against the cross member when the engine is running. Looks like the only way to have enough clearance is to weld it in place. but as I then have to remove the whole front assembly, I might as well buy the complete assembly ready made.
|
It's on the truck now and works a treat, I did find that at idle sometimes there was a slight rattle somewhere, it turned out that I just had to spin one of the clamps around as it was catching on the front prop
It's been fine since