Quote:
Originally Posted by Banshee
It's on the truck now and works a treat, I did find that at idle sometimes there was a slight rattle somewhere, it turned out that I just had to spin one of the clamps around as it was catching on the front prop
It's been fine since
|
Cheers.... I need to basically lift Suz's exhaust up so it sits higher under up, nearer the body floor pan, but I can't see any way to adjust it. The "U" part of the clamp only has about 5mm of clearance above the cross member, and as it is, it runs through the mounting on the gearbox, so if I raised it any higher, it would be above that mount.